9.8. Removal and installation to the place of the sensor of a detonation (DI/APC system)



1. The sensor of a detonation is located in a back part of the block of cylinders under the inlet pipeline. Previously a car front also establish to a poddomkratta it on axial support (address Poddomkrachivaniye's Section, towage and change of wheels).
2. Disconnect a wire from the detonation sensor.
3. Unscrew the detonation sensor from the block of cylinders.

Installation into place


1. Clear carvings of the sensor of a detonation and an opening in the block of cylinders.
2. Insert the sensor of a detonation and tighten it with the required effort.
3. Connect wires and lower the car on the earth.

Tightening of the sensor with the required effort is an important point, otherwise it will give the wrong signal in the electronic actuation device.