9.10. Removal and installation to the place of sensors of position of the crankshaft (DI/APC system)

For models with control systems of the Trionic engine address the Section Removal and installation to the place of components of system of injection of fuel (Trionic).

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire of the battery.
2. Cock the emergency brake, then a front of the car and establish to a poddomkratta it on axial support (address Poddomkrachivaniye's Section, towage and change of wheels). Remove the right forward wheel.
3. Give screws and remove a plastic molding and forward section of a loker of an arch of a wheel under an arch of the right forward wheel.
4. Where is available, remove a driving compressor belt of the air conditioning system.
5. Take off an auxiliary driving belt (The head Routine maintenance).
6. Now when weakening a bolt of a pulley of the crankshaft, the crankshaft has to be kept by motionless. Let the assistant will insert the screw-driver with a wide sting into a distributive opening in the top part of transmission and will jam it between teeth of a gear wreath of a starter.
7. Give and remove a crankshaft pulley bolt. The bolt is tightened very strongly and its otdavaniye requires a face key with the extender. In extreme cases for removal simplification the bolt can be warmed, however observe at the same time the appropriate measures of precaution. After removal of a bolt remove a pulley from a crankshaft pin.
8. Remove screws and take out the sensor from a cover of a distributive chain.
9. Disconnect the electric socket located behind the battery and take out the sensor from a motive compartment. If necessary release a wire from a trosikovy collar.

Installation into place

Installation is into place made as it should be the return to a removal order, at the same time grease carvings of fixing screws of the sensor with the fixing liquid before inserting and tightening screws.