17:15. Removal and installation to the place of draft and the motor of a screen wiper of a windshield, glass of a door of a back and lenses of the main headlights

In order to avoid risk of casual short circuit, disconnect a negative wire of the battery and shift it from the plug aside. Only after it get to work.

Motor and draft of a screen wiper of a windshield

Removal

 PERFORMANCE ORDER

1. Remove both levers of a screen wiper ( The section Removal and installation to the place of levers of screen wipers of a windshield, glass of a door of a back and the main headlights).
2. Remove rubber sealing plugs or plastic moisture protective covers (depending on what is established) from a spindle shaft.
3. On late models remove plastic finishing model from bottom edge of a windshield by extraction of clamps in the form of tightening hairpins and removal of covers from both sides of loopback edge of a cowl. Carefully take bottom edge of a sealing strip of a windshield and having shifted, remove the finishing panel.
4. Access to the motor and draft of a screen wiper can be provided by removal of the false panel of a partition and a cover; give two fixing screws from each party and remove the panel (The section Removal, division and installation to the place of the engine and transmission).
5. Disconnect electric sockets of cables from the screen wiper motor - mark them for simplification of the subsequent installation.
6. By means of a wrench weaken and remove nuts of a driving spindle of a screen wiper. Pay attention that on late models driving spindles of a screen wiper are equipped with lengthenings of shaft which are fixed on a body by separate bolts.
7. Give four fixing bolts of assembly of the motor of a screen wiper.  
8. Using the screw-driver as the lever, disconnect a draft rod from the spherical hinge of a shaft of lengthening of the left screen wiper. Remove other end of a rod of draft from the spherical hinge of the driving lever of assembly of the motor of a screen wiper.
9. Remove assembly of the motor and a rod of draft of the left screen wiper. Remember position of the lever of the drive of a screen wiper in an initial state, for simplification of the subsequent assembly.
10. The rod of draft of the right screen wiper can be removed similarly. Pay attention that on late models shaft of lengthenings of driving spindles are established and between two lengthenings of shaft the bracket is established. Before shaft of lengthenings can be otbolchena, this bracket has to be removed by a vyvinchivaniye of a through bolt.

Installation into place

Installation of the motor and draft of a screen wiper is into place carried out as it should be, the return to a removal order; track that the driving lever of the motor of a screen wiper in a starting position, fell into the same state, as before assembly, only behind that start connection of a rod of draft.

Back door glass screen wiper motor

Removal

 PERFORMANCE ORDER

1. Remove the back door screen wiper lever (The section Removal and installation to the place of levers of screen wipers of a windshield, glass of a door of a back and the main headlights).
2. Give a spindle nut, then remove rubber consolidation.

3. Open a door of a back and remove the panel of internal finishing (The head Body works).
4. Disconnect the electric socket of a cable of the motor of a screen wiper.
5. Weaken fixing bolts and omit assembly of a screen wiper, having disconnected it from a back door, carrying out a driving spindle through a back door opening.

Installation into place

Installation of assembly of the motor of a screen wiper of a door of a back is into place carried out as it should be, the return to a removal order. Track that three damping rubber plugs were installed into place correctly, then tighten fixing bolts.

Motor of a screen wiper of the main headlights

On early models one-reflex blocks of the main headlights, assembly of the motor of a screen wiper of a pribolchen to the lower part of the block of a headlight are installed.

On late models two-reflex blocks of the main headlights and assembly of the motor of a screen wiper of a pribolchen to a body directly under the headlight block are installed.