16:25. Removal and installation to the place of panels of internal finishing

Panels of finishing are resistant And

 PERFORMANCE ORDER

1. Open the corresponding forward door and remove a sealing rubber strip of a doorway on a rack And.
2. Moving from a ceiling down, firmly holding the panel, gradually remove it from a rack, disconnecting for once on one tightening clamp.
3. For installation into place, bring the panel to a rack and, for accession, firmly press each block of a clamp. Insert into place a sealing strip of a doorway.

Panels of finishing are resistant In

Finishing panels of a rack In form a cover of assembly of an inertial drum of a seat belt (detailed information on their removal is provided in the Section Removal and installation to the place of components of seat belts).

Panels of finishing are resistant With

 PERFORMANCE ORDER

1. Open the corresponding back door and remove from a doorway on a rack About a rubber sealing strip.
2. Remove the passenger bulb intended for reading (see the Head Sistem of electric equipment).
3. Moving on the outer edge, carefully release the panel, having separated it from a rack With, releasing on one press clamp at one time.
4. For installation of the panel into place, bring it to a rack and firmly press each block of a press clamp. Insert into place a sealing strip of a doorway and establish the passenger bulb intended for reading.

Ceiling upholstery

The ceiling upholstery, by means of clips, is fixed on the panel of a roof and the movable hatch (where it is established), panels of finishing of racks, blocks of internal lamps can be lowered only after removal of all elements of finishing, such as gripping handles, sun-protection guards, down. Also consolidations of doorways at the same time have to be removed from a car body (and where are available, doors of a back and the hatch of a roof).

Implementation of the procedure of removal of a ceiling upholstery demands certain skills and qualification therefore, in order to avoid damage of material of an upholstery and elements of finishing of salon, it is better to provide this work for performance to experts.

Panel of internal finishing of a door of a back

 PERFORMANCE ORDER

1. Open a door of a back and remove clamps of the panel of internal finishing, turning each of them on a quarter of a turn counterclockwise.
2. Give fixing screws and remove the internal gripping handle.
3. From the inside of bottom edge of back glass unscrew fixture from the ends of rigid plastic finishing panels. Carefully remove the panel of internal finishing from a back door.
4. Installation of the panel is into place carried out as it should be, the return to a removal order.

Cover of a spare wheel

 PERFORMANCE ORDER

1. Take out tightening hairpins, then give fixing screws and remove the plate intended for protection of a threshold of the luggage compartment against deleting together with the rug panel which is with it a whole.
2. Incline a back of a back seat forward, then give screws and remove the panel intended for protection against deleting of a forward part of the luggage compartment.
3. Three screws near the loopy hinge fix a cover of a spare wheel to the floor panel; give them and uncover, having taken out it from the luggage compartment.
4. Installation of a cover is into place carried out as it should be, the return to a removal order.

Panels of finishing of walls of the luggage compartment

 PERFORMANCE ORDER

1. Uncover a spare wheel.
2. Remove plastic covers from hairpins which fix the finishing panel to a back part of the luggage compartment, then remove rubber consolidation from edge of a doorway of a back.
3. Moving from a doorway carefully delay the panel from a wall of the luggage compartment. Under the holder of the back panel of salon a car / bracket of loudspeakers, by means of the screw-driver, release from cuts in the finishing panel plastic ears.
4. Unscrew the fixing plug of a seatback from a ledge of a forward part of an arch of a wheel and remove a metal back plate.
5. Having weakened fixing screws, exempt a finishing panel corner from the panel intended for protection of an aperture of a back door against deleting.
6. Carefully separate the finishing panel rest from a body and remove it from the car.