16:16. Removal and installation to the place of components of the lock of a door of a back / trunk lid

Clamp

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire of the battery and shift it from the plug aside.
2. Remove the panel of an internal covering of a door of a back (The section Removal and installation to the place of panels of internal finishing).
3. Weaken and take three fixing bolts of assembly of a clamp.
4. Disconnect the plug from the electric socket.
5. Disconnect a rope of draft of the uniform lock from assembly of a clamp by turn of a metal hook on the end of a rope for a detachment it from the activator lever. Remove assembly of a clamp from a back door.

Installation into place

Installation of assembly of a clamp into place, is carried out as it should be the return to a removal order. In conclusion check functioning of a clamp; if for a zashchelkivaniye of a clamp application of excessive effort or in case of leaky gearing of a clamp is demanded at the closed door, make adjustments of a plate of the drummer according to the instruction provided in the following subsection.

Drummer's plate

Removal

 PERFORMANCE ORDER

1. Remove fixing screws and take out a basic plate.
2. Weaken and take two fixing bolts, then remove the drummer's plate.

Installation into place

Installation is into place carried out as it should be the return to a removal order, the procedure of adjustment of position of the drummer is described below.

Adjustment

Adjusting openings for bolts of a plate of the drummer are extended, for a possibility of smooth adjustment. Slightly weaken bolts and change the provision of a plate of the drummer. For harder closing of a clamp shift a plate down, and for easing - up. Again tighten bolts, close the fifth door and check reliability of closing of a clamp.

Lock cylinder

Removal

 PERFORMANCE ORDER

1. Remove the panel of an internal covering of a door of a back (The section Removal and installation to the place of panels of internal finishing). Remove two fixing screws from assembly of the cylinder of the lock. For extraction of the cylinder from an opening at doors of a back turn the cylinder.
2. Disconnect a draft rope tip from a pulley and remove the cylinder.

Installation into place

Installation of the cylinder of the lock is into place carried out as it should be, the return to a removal order.