16:15. Removal and installation to the place of a door of a back and an emphasis of a door of a back

Back door

Removal

The help of the assistant is necessary for carrying out this operation.


 PERFORMANCE ORDER

1. Disconnect a negative wire of the battery and shift it from the plug aside.
2. Remove the panel of an internal covering of a door of a back (The section Removal and installation to the place of panels of internal finishing).
3. Disconnect electric sockets of the motor of the drive of the uniform lock, the switch of "an open door", fog lights, fires of a backing and illumination of registration plate, and also a screen wiper of back glass. Mark each socket in order to avoid their pereputyvaniye at assembly.
4. There where are available, uncover brake fires of the top level (The head Sistema of electric equipment), disconnect wires from the socket. Disconnect a hose from a nozzle of windscreen washer of a back window. In case the old door of a back is established into place, tie up by the ends of cables of a string, for simplification of drawing of cables back at installation of a door.
5. Put a leaf of a substrate on the rear edge of a roof of the car. Take rubber sealing plugs and take out cables and a hose of windscreen washer from a back door, having spread out them on a substrate, in order to avoid car roof paint damage.
6. A thick prop of the required length, prop up a back door. Unclench fixing clips, then disconnect the top ends of an emphasis from spherical fingers of a door of a back.
7. On each loop weaken and remove two axial screws, then remove the main fixing bolts and divide two halves of each loop. Provide reliable support of a door, in order to avoid its inclination.
8. By means of the assistant, remove a door of a back and lower it on the earth, having enclosed previously a leaf of a substrate. In case of installation of an old door into place, leave the ends of the strings which are tied up to cables, sticking out so that later was possible to extend for them cables.

Installation into place

Installation of a door of a back is into place carried out as it should be the return to a removal order. In case of replacement of a door by new, transfer to it with old all auxiliary components before establishing a door into place. Close a door and check functioning of the mechanism of the clamp / lock. In case for normal closing of a door it is required to put excessive effort, or in case of leaky closing of a clamp, make adjustments of a plate of the drummer (address the Section Removal and installation to the place of components of the lock of a door of a back/trunk lid).

Back door emphasis

Removal

 PERFORMANCE ORDER

1. Prop up a door a thick core of suitable length.
2. Vykovyrnite from spherical hinges of the top ends of an emphasis fixing clips, then it is careful, by means of the lever, take hinges from spherical fingers on a back door.
3. Repeat the procedure with the lower ends of an emphasis, then remove an emphasis from the car.

At removal of an emphasis you watch that the propped-up door was completely open and an emphasis, respectively, is nominated to full length, otherwise they can suddenly be moved apart at their removal from a door.

Installation into place

Installation of an emphasis on the place is carried out as it should be, the return to a removal order.