15:10. Removal and installation to the place of a jet bar of a back suspension bracket
Removal
|
1. Park the car on the flat platform, prop up forward wheels and establish a control lever by the transmission in the provision of the first transfer (the manual transmission) or the selector lever in situation "P" (automatic transmission). On the corresponding wheel take off a decorative cap of a disk of a wheel. Weaken bolts of fastening of a wheel. 2. A back part of the car also establish to Poddomkratta it on axial support. Remove a back wheel. |
3. Otboltite fixture on each end of a jet bar, on the panel of a floor and top part of an arm of a nave. |
|
4. Lower the leading end of a bar from a bracket on the panel of a floor and, then, push out the conducted end from a nave arm. After release of a bar remove plugs 5. Examine plugs regarding detection of signs of wear and destruction, if necessary replace them. |
|
Installation into place
Establish a jet bar into place, working as it should be the return to a removal order.