14:16. Removal, check and installation to the place of the switch of an alarm lamp of the emergency brake

Removal

 PERFORMANCE ORDER

1. The switch of an alarm lamp of the emergency brake is installed on a bracket, pribolchenny to the floor panel, directly under the lever of the emergency brake. For ensuring access to it remove back section of the central console (address the Head Body works).
2. Park the car on the flat platform and cock the emergency brake.
3. Remove the bolt fixing an adjusting bracket to the floor panel, and disconnect the switch plug from the electric socket. Remove assembly of the switch.

Check

 PERFORMANCE ORDER

1. The switch is in normally closed situation. Functioning of the switch can be checked as by means of the tester (included on measurement of resistance), and the conductivity indicator manufactured of a bulb, the battery and two pieces of a wire. Connect the tester / indicator to switch plugs (the order of connection does not matter). The switch at the same time has to remain not pressed. In case the switch is serviceable, the device will show short circuit (no more than 1 or 2 Ohms).
2. Press a plunger of the switch and repeat measurements. Now the device has to show the opened contour (very high resistance or not burning indicator lamp).
3. If the switch does not function as it is described above or conditions of inclusion switching off are unstable, it has to be replaced.

Installation into place

 PERFORMANCE ORDER

1. Priboltite an adjusting bracket of the switch to the floor panel also connect its plug to the electric socket.
2. Once again make sure that the car is parked on the flat platform. Install the lever management of the transmission in the provision of the first transfer (the manual transmission) or the selector lever in situation "P" (automatic transmission), cock the emergency brake and include ignition - but do not start the engine.
3. Release the emergency brake and make sure that the metal ear acting from the lever in its lower situation perpendicularly rests against a plunger of the switch and presses it down. The alarm lamp of raising of the emergency brake on an instrument guard has to be switched off.
4. Again cock the emergency brake and make sure that the metal ear does not concern a switch plunger now, allowing it to return to a starting position completely. The alarm bulb on an instrument guard has to be included.
5. Establish into place back section of the central console (address the Head Body works).