9.6. Removal and installation to the place of the block of ignition (DI/APC system)
Removal
|
|
| 1. Disconnect a negative wire of the battery. |
| 2. Give 4 screws of fastening of the block of ignition in the top part of a head of cylinders. Here application of a key of a hexagon will be required. |
|
3. Where is available, give a bolt and release ignition block wires from the holder's clip.
4. Where is available, give a bolt and disconnect the grounding tire. |
| 5. Disconnect the electric socket (sockets) of the system located or behind the battery (not Trionic), or on the left side of the block (Trionic). |
|
| 6. Lift the ignition block, at the same time removing it from the top tips of candles. |
| 7. If necessary the casing can be removed from the lower part of the block by its turning and removal of screws by means of a hexagon key. Separate a black (lower) casing from the block. |
|
| 8. Carefully by means of the screw-driver take out high-voltage springs from a casing. |
|
Installation into place
Installation is into place made as it should be the return to a removal order, at the same time tighten fixing bolts with the required effort.