9.12. Removal and installation to the place of the sensor of pressure (DI/APC system)

For models with a control system of the Trionic engine address the Section Removal and installation to the place of components of system of injection of fuel (Trionic). The sensor is called the sensor of absolute pressure of the pipeline (MAP) there.

Removal

 PERFORMANCE ORDER

1. The sensor of pressure is located under the forward panel (torpedo) at the left. Previously disconnect a negative wire of the battery.
2. Remove the lower decorative panel located under the forward panel.
3. Give screws and remove an air sleeve of a heater.
4. Give fixing screws, lower pressure sensor from a partition, then disconnect wires.

Installation into place

Installation is into place carried out as it should be the return to a removal order.