9.11. Removal and installation to the place of a rotor with cuts for the crankshaft sensor (DI/APC system)

Removal

Models not Trionic

 PERFORMANCE ORDER

1. Remove a crankshaft pulley.
2. By means of a face key hexagon give fixing screws and remove a rotor from a crankshaft pulley.

Trionic models

 PERFORMANCE ORDER

1. The rotor is located on the end of the crankshaft turned to a flywheel / to a driving disk. Remove the crankshaft (see the Head Remont of the engine).
2. By means of a key like "Torx" give 4 screws fixing a rotor to the crankshaft then remove a rotor from a crankshaft pin.

Installation into place

Models not Trionic

Installation is into place made as it should be the return to a removal order.

Trionic models

Installation is into place made as it should be the return to a removal order. Pay attention that the rotor can be established into place by the only way as openings under bolts are located asymmetrically.