6.3. Removal, installation into place and adjustment of a rope of an accelerator

Removal

 PERFORMANCE ORDER

1. Weaken collars and remove an inlet sleeve from the case of a throttle and the inlet pipeline.
2. Where is available, pick up the phone of recirculation of the fulfilled gases (EGR).
3. Release an internal rope of an accelerator from the sector of the case of a throttle. The end of an internal rope can be clamped to the sector, in this case for a release of a clip use the screw-driver.
4. Pull out a rope and disconnect an external rope of an accelerator from a bracket on the throttle case.
5. In interior of the car delay isolation over an accelerator pedal. On models with the left steering remove the left panel of the central console. On models with the right steering pay attention that the pedal has lengthening with an exit to the left side of the forward panel ("Torpedo") therefore it is also required to remove isolation and on the left side of the car.
6. On models since 1994 of the issue disconnect a ball chain of a tempostat from a lock level. For the subsequent installation notice for yourself the provision of a lock level.
7. Holding an accelerator pedal in the pressed situation, disconnect a lock level from a rope, then disconnect a rope and the plug from an accelerator pedal in the car.
8. Tie up a piece of a string by the end of a rope of an accelerator, then you vykovyrnit a rope flange from a partition by means of the screw-driver.
9. Involve a rope in a motive compartment, then untie a string and remove a rope.

Installation into place

 PERFORMANCE ORDER

1. Slightly grease an accelerator rope flange with vaseline. Tie up a piece of a string or a wire to a rope and drag a rope through a partition. By means of the big screw-driver insert a flange into a partition.
2. Connect in the car a rope and the plug to an accelerator pedal.
3. Untie a string and establish into place a lock level. Before releasing a pedal, fix a lock level by an insulating tape.
4. On models of 1994 of the issue establish a ball chain of a tempostat in previously marked situation.
5. Establish into place isolation and on models with the left steering the left side panel of the central console.
6. Fix an external rope of an accelerator on a bracket of a casing of a throttle and record it a clip.
7. Connect an internal rope to the sector of a casing of a throttle, and there where it is necessary, clamp clips by means of flat-nose pliers.
8. Tighten up a regulator nut on an external rope so that the rope slightly sagged at a pedal otpuskaniye.
9. Where it is necessary, connect into place a tube of system of recirculation of the fulfilled gases (EGR).
10. Establish into place between the case of a throttle and the inlet pipeline an air sleeve and tighten collars.