6.19. Removal and installation to the place of the heat exchanger (intercooler) of a turbocompressor

Removal

 PERFORMANCE ORDER

1. Remove a radiator (The head of the Cooling system, heating).
2. Where is available, remove plastic protection from under the heat exchanger.
3. Weaken collars and disconnect hoses from each end of the heat exchanger.
4. Give and remove bolts of fastening of the heat exchanger to the condenser of the air conditioning system.
5. Remove the top fixing bracket and sealing plugs from hairpins of the top part of the heat exchanger and condenser.
6. Remove the heat exchanger from the forward panel, remove it from support and take out from a motive compartment.

Installation into place

 PERFORMANCE ORDER

1. Check a condition of sealing plugs of the top basic bracket, if necessary replace them.
2. Lower the heat exchanger on the support.
3. Shift the heat exchanger against the condenser forward, then install the top basic bracket and sealing plugs on hairpins, on the heat exchanger and the condenser. The end of a support of a radiator has to look back.
4. Establish bolts of fastening of the heat exchanger to the condenser of the air conditioner, tighten them with the required efforts.
5. Connect a hose to each end of the heat exchanger and tighten collars.
6. Where is available, establish into place under the heat exchanger plastic protection.
7. Establish into place a radiator (The head of the Cooling system, heating).