4.1.7. Removal, survey and installation to the place of guides and a natyazhitel of a distributive chain

Removal

REMOVAL

1. Remove a distributive chain (address the Section Removal, survey and installation to the place of a distributive chain and asterisks). On models with balancing shaft this procedure includes removal of the fixing guide and guides of a chain of a balancing shaft. On engines with balancing shaft removal of a distributive chain from a crankshaft asterisk is not required.

2. Otboltite also remove the fixing guide of a distributive chain
(B202 engines), also take off from an axial finger on the block of cylinders a boot of a natyazhitel of a chain from a finger on the block of cylinders (B204 engine).

Survey

Components of a natyazhitel of a distributive chain of model till 1988 of the issue.


Section of a natyazhitel of a distributive chain of models since 1988 of the issue.


 PERFORMANCE ORDER

1. Examine a guide and a boot regarding detection of damages and excessive wear, if necessary replace them.
2. Smooth out a plunger and the case of a natyazhitel, examine them regarding damages and wear. On the models made till 1988, the plunger is taken after an otzhatiya of the fixing doggie. In case the surface of a plunger or the case of a natyazhitel are strongly scratched, the natyazhitel has to be replaced in a set.

Installation into place

INSTALLATION

1. Establish a boot on a finger on the block of cylinders, then establish the fixing guide and tighten fixing bolts.
2. Establish into place a distributive chain (address the Section Removal, survey and installation to the place of a distributive chain and asterisks).