4.1.4. Removal and installations to the place of a cover of a head of cylinders

REMOVAL

1. Disconnect plugs from the block of ignition of system of direct ignition. Give screws and remove a viewing cover, or the ignition block in system with direct ignition, in the central part of a cover of a head of cylinders (if it is required see the head Sistemy of start and a charge).

2. On the models which are not equipped with direct ignition disconnect high-voltage wires from candles.

3. Remove fixing screws of a cover of a head of cylinders and remove it.

4. Then remove internal laying and the special split rubber traffic jams.

5. On later models the split rubber traffic jams are built in external laying.

6. Pay attention that on early models the split rubber traffic jams are installed separately while on later models, they are built in external laying. In case the cover stuck to a head of cylinders, for moving slightly clap on it a palm.

INSTALLATION

1. Clear contact surfaces of a cover of a head of cylinders and the head of cylinders. On early models establish the special split rubber traffic jams on a head of cylinders, then apply a 4-millimeter pillow of silicone sealant on corners of a head and on rubber traffic jams.

2. On late models establish the combined rubber ring in a flute in a cover of a head of cylinders.
3. Establish into place a cover of a head of cylinders and insert fixing bolts. Tighten bolts in the progressing order with the required effort, since the neighbor's bolts to the distributor of the end of a head and average bolt of the distributive end.
4. On models with the system of ignition equipped with the distributor connect high-voltage wires to spark plugs.
5. Establish into place a viewing cover or the block of ignition of system of direct ignition in the center of a cover of a head of cylinders and tighten screws.