4.1.13. Removal and installation to the place of the sensor switch of an alarm lamp of oil pressure

Removal

 PERFORMANCE ORDER

1. On the engines which are not equipped with balancing shaft, the switch is screwed in in the top part of the adapter of an oil filter in a back part of the block of cylinders. On the engines equipped with balancing shaft, the switch is screwed in in a back part of the block of cylinders under the inlet pipeline. At first the car in front and behind also install to a poddomkratta it on axial props (address Poddomkrachivaniye's Section, towage and change of wheels).
2. Disconnect a wire from the sensor plug.
3. Unscrew the sensor from the adapter of an oil filter or the block of cylinders. Prepare for the possible passage of oil. If the sensor is taken out on more or less long period, stop up an opening, in order to avoid hit in it of dirt or dust.

Installation into place

 PERFORMANCE ORDER

1. Purely wipe carvings of the sensor and an opening under the sensor, insert the sensor and strong tighten it.
2. Connect a wire to the sensor plug.
3. Start the engine and examine the sensor switch regarding detection of leaks. Lower the car on the earth.