4.1.12. Removal and installation to the place of the oil cooler

Removal

 PERFORMANCE ORDER

1. The oil cooler is established only on the models equipped with system of a turbo-supercharging. The cooler is connected to openings on the adapter installed on an oil filter. Also oil thermostat is a part of the adapter.
2. For removal of the oil cooler at first the car in front and behind also establish to a poddomkratta it on axial props (address Poddomkrachivaniye's Section, towage and change of wheels). If necessary merge motive oil (see the Head Routine maintenance), then establish into place and tighten a drain stopper.
3. Place a container of suitable volume under the oil cooler in the right part of a motive compartment. Unscrew unions in the top and lower parts of the oil cooler and disconnect maslopodayushchiya and maslovozvratny hoses. Let's oil flow down in a container.
4. Give bolts and remove the oil cooler. On early models of an opening of bolts of the lower support have cuts and therefore the lower bolts have to be weakened only. Remove the oil cooler and take out it from a motive compartment.

Installation into place

Installation is into place made as it should be, the return to a removal order. Unions should be tightened with the required effort. Fill in the engine with fresh motive oil (see the Head Routine maintenance). In conclusion start the engine and let's it work at turns of bystry idling within several minutes in order that oil filled the oil cooler. Check the level of motive oil, if necessary make a dolivaniye (see the Head Routine maintenance).