16.6. Removal and installation to the place of a front bumper



1. Park the car on the flat platform, cock the emergency brake and prop up back wheels. A car front also establish to Poddomkratta it on axial support (address Poddomkrachivaniye's Section, towage and change of wheels).
2. There where is available, remove fixing screws, then lower the pallet and sleeves of cooling of brakes, having taken out them from under the car; pay attention that a forward part of the pallet is fixed by clips at edge of a spoiler.
3. Give fixing screws and separate a spoiler from a bumper. There where are established, disconnect wires of riding / fog lights and the sensor of surrounding temperature.
4. Weaken two through bolts fixing a bumper to a forward stretcher.
5. Disconnect the ends of a bumper from side moldings of a body, then remove a bumper from the car.
6. Now the external molding of a bumper can be separated from the internal metal basis by removal of fixing screws.

Installation into place

Installation of a bumper is into place carried out as it should be, the return to a removal order; make sure that the ears acting from a forward wing get to the corresponding deepenings on the ends of a bumper.