16:23. Removal and installation to the place of seats

Front seats

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire of the battery and shift it from the plug aside.
2. There where there are regulators of height of provision of a seat, make sure that they are in the lower situation.
3. Insert the small screw-driver into the done cut and remove a plastic cover from the handle of adjustment of an inclination of a seatback. Give the fixing screw and remove the handle.

4. Take out plastic caps from the side panel and give the fixing screws which are under them.

5. Otboltite from directing seat rail a bracket of fastening of a seat belt.

6. Weaken and take bolts of fastening of directing seat rail to the floor panel.
7. Incline a seat back and you oboprit a back about a back seat, avoiding a tension of cables below. Disconnect the plug of wires of an element of a heater of the seat located on the bracket established on a floor from the electric socket.
8. At removal of a passenger seat, unhook the switch from a wire on the lower party of a pillow of a seat, having remembered a point of its accession.
9. Take out a seat from interior of the car.

Installation into place

Installation of front seats is into place made as it should be the return to a removal order taking into account the next moments:

   a) Track that all electric wires were correctly connected; at installation of a passenger seat, make sure that press the switch is hooked under a seat pillow in the correct situation noticed at removal.
   b) At installation to the place of a bracket of fastening of a seat belt, insert an ear into a cut on a seat bracket. In spite of the fact that efforts of tightening of fixing nuts are not stipulated in Specifications, watch that nuts were tightened hardly. There where are established самоконтрящиеся nuts, ideally, at installation of a seat into place, it is necessary to replace nuts with new.

Backs of back seats

Removal

 PERFORMANCE ORDER

1. By means of belt loops lift a pillow of a seat and incline it completely forward.
2. Backs of a back seat are established on brackets which pribolchena to the floor panel in three points. For removal of both backs at the same time, unbend a rug back, you otboltit adjusting brackets from the floor panel, unhook bottom edge of an upholstery of a seat from brackets of fastening of seat belts and remove backs.
3. For separate removal of backs unscrew from loops at the edges of a back fixing screws.

Installation into place

Installation of backs of a back seat is into place carried out as it should be, the return to a removal order.

Pillow of a back seat

Removal

 PERFORMANCE ORDER

1. By means of belt loops lift a pillow of a seat and incline it completely forward.
2. Remove the screws fixing a metal back plate to a bar of loops then remove a pillow.
 

Installation into place

Installation of a pillow of a back seat is into place carried out as it should be the return to a removal order. Before tightening fixing screws, make sure that the pillow is established on beams of loops exactly and is not twisted.