16:17. Removal and installation to the place of motors of drives of the uniform lock

Motors of drives of locks of doors

The procedure is identical both to locks of lobbies, and to locks of back doors.

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire of the battery and shift it from the plug aside.
2. Remove the panel of an internal covering of a door (The section Removal and installation to the place of an internal covering of doors).
3. Disconnect the plug of the driving motor from the electric socket of a plait of wires.
4. Remove two screws of fastening of the motor of the drive.

5. Disconnect a plunger from the blocking mechanism and take out the drive motor.

Installation into place

Installation of the block is into place carried out as it should be, the return to a removal order.

Motor of the drive of the lock of a door of a back / trunk lid

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire of the battery and shift it from the plug aside.
2. Remove the panel of an internal covering of a door of a back (The section Removal and installation to the place of panels of internal finishing).
3. Disconnect the drive motor plug from the electric socket of a plait of wires.
4. Remove two fixing screws of the driving motor.
5. Disconnect a plunger from the blocking mechanism and remove the drive motor.

Installation into place

Installation of the block is into place carried out as it should be, the return to a removal order.

Motor of the drive of the lock of a mouth of the gulf of fuel

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire of the battery and shift it from the plug aside.
2. Remove the side panel of a covering of the luggage compartment (The section Removal and installation to the place of panels of internal finishing).
3. Disconnect the drive motor plug from the electric socket of a plait of wires.
4. The motor of the drive is installed on a metal bracket which приболчен from within to a wing. For release of a bracket give three fixing nuts, then separate from a bracket the motor by removal of two screws.
5. Unhook a plunger from the blocking mechanism and remove the drive motor.

Installation into place

Installation of the block is into place carried out as it should be, the return to a removal order. At installation to the place of the side panel of a covering, make sure that the rope of manual opening of the lock is in the luggage compartment.