16:11. Removal, installation into place and adjustment of doors

Forward doors

Removal

On early models it will be required to remove the panel of an internal covering of a door (address the Section Removal and installation to the place of an internal covering of doors) and to extend a plait of wires from the sealing plug in the region of a door, then having separately disconnected electric sockets.

On early models it will be required to beat out a roller finger from a limiter bar, having used for this purpose the hammer and a drift; at installation into place it is necessary to use a new roller finger.


 PERFORMANCE ORDER

1. Disconnect a negative wire of the battery and remove it from the plug aside.
2. For ensuring access to the electric socket of a plait of wires open a door. The small screw-driver you vykovyrnit a blocking core from a casing of the electric socket; it will allow to squeeze the blocking mechanism, having released it from a case opening.
3. Take the electric socket from an opening together with rubber consolidation and divide two of its halves.


4. Remove the screw and disconnect a limiter bar from a fastening point on the case.

5. On late models remove screws of the top and lower loops.
6. Open a door so widely that on both parties of a loop the notch and an ear were combined.
7. Perpendicularly remove a door from loops and accurately lower on a substrate for protection of its edges.

Installation into place

Installation of a door is into place carried out as it should be, the return to a removal order.

Back doors

Removal

 PERFORMANCE ORDER

1. Remove the panel of an internal covering (The section Removal and installation to the place of an internal covering of doors).
2. Disconnect all electric sockets of the drive of the uniform lock, the electric motor of opening of a window and the sensor of "an open door" (where it is established). For simplification of the subsequent assembly mark wires and sockets. Take plaits via the sealing plug of edge of a door.
3. The further order of removal of a door is similar to an order of removal of a forward door.

Installation into place

Installation of a back door is into place carried out as it should be, the return to a removal order.