15.9. Removal and installation to the place of back screw springs

Removal

 PERFORMANCE ORDER

1. Park the car on a plain surface, prop up forward wheels and establish a control lever by the transmission in the provision of the first transfer (the manual transmission) or the selector lever in situation "P" (automatic transmission). On corresponding wheels take off a decorative cap of a disk and weaken bolts of fastening of a wheel.
2. A back part of the car also establish to Poddomkratta it on axial support.
3. Disconnect a rope of the emergency brake from the suspension bracket lever, having removed a collar from a tightening hairpin.
4. Establish a jack at the end of the lower lever of a suspension bracket, then remove a bolt which fixes the lever to an axis pipe (address the Section Removal and installation to the place of the lower lever of a back suspension bracket).
5. By means of a jack lower the lever so that the screw spring could be removed from the place, remove a rubber saddle.

Installation into place

 PERFORMANCE ORDER

1. Establish on the places, on the lower lever of a suspension bracket a spring and a rubber saddle; you watch that the step lower end of a spring connected to a ledge on the suspension bracket lever.
2. By means of a jack lift the suspension bracket lever, watching that the top part of a spring perpendicularly rose on the top saddle.
3. Establish into place a bolt which fixes the conducted end of the lever of a suspension bracket to a pipe of an axis and strong tighten it.
4. Screw a bracket of a rope of the emergency brake on the place on the edge of the suspension bracket lever.
5. Establish into place a wheel and bolts of fastening of a wheel, then lower the car on the earth and tighten bolts with the required effort. Establish into place a decorative cap of a disk of a wheel.