15.8. Removal and installation to the place of the back stabilizer of cross stability

Removal

 PERFORMANCE ORDER

1. Park the car on the flat platform, prop up forward wheels and establish a transmission control lever in the provision of the first transfer (the manual transmission) or the selector lever in situation "P" (automatic transmission). Take off decorative caps of disks of back wheels and weaken bolts of fastening of wheels.
2. A back part of the car also establish to Poddomkratta it on axial support, remove wheels (address Poddomkrachivaniye's Section, towage and change of wheels).
3. On one of the parties of the car establish a jack under connection between a pipe of an axis and the lower lever of a suspension bracket. Cock a jack on so many to unload the shock-absorber and the stabilizer of cross stability.
4. Working, according to the corresponding procedures of the Section Removal and installation to the place of the back shock-absorber you otboltit the stabilizer of cross stability from a support on an axis pipe. Repeat the procedure, working from other board of the car.
5. Exempt the stabilizer of cross stability from internal support, by removal of two bolts of fastening of U-shaped brackets to suspended brackets.

6. Take out the stabilizer of cross stability from under the car and remove plugs of internal support.
7. Examine rubber plugs regarding detection of signs of wear or destruction; at deformation, splitting or strong wear of plugs they are subject to replacement. Examine the stabilizer of cross stability regarding detection of cracks, paying special attention to adjusting points.

Installation into place

Install into place the stabilizer of cross stability, working as it should be the return to a removal order, taking into account the next moments:

   a) Tighten a bolt of the lower support with the required effort.
   b) Establish into place a wheel, lower the car on the earth and tighten bolts of fastening of a wheel with the required effort.