15.4. Removal and installation to the place of the forward stabilizer of cross stability

Removal

 PERFORMANCE ORDER

1. Park the car on the flat platform, cock the emergency brake and prop up back wheels. Remove decorative caps and weaken bolts of fastening of wheels.
2. A car front also establish to Poddomkratta it on axial support (look Poddomkrachivaniye's Section, towage and change of wheels). Remove forward wheels.
3. Weaken and remove bolts of U-shaped brackets on a stretcher, then release from them the stabilizer of cross stability.
4. On one of the parties of the car remove three nuts which fix the lower lever of a suspension bracket to a spherical support in the basis of a rotary fist of the steering mechanism.
5. Remove a nut of fastening of a rack of the stabilizer of cross resistance to the suspension bracket lever; remove plugs and washers.
6. Weaken a nut on the end of the stabilizer of cross stability for ensuring the free movement of a rack, then press down the lever of a suspension bracket and take from it a stabilizer rack.
7. Repeat the procedure with the suspension bracket lever from other board of the car.
8. Carefully take the stabilizer of cross stability from under the car.
9. Examine rubber plugs of U-shaped brackets on a stretcher and a rack of the stabilizer of cross stability regarding detection of signs of wear or destruction; replace the deformed, wiped or split plugs.
10. Examine the stabilizer of cross stability regarding detection of cracks, paying special attention to reference points.

Installation into place

 PERFORMANCE ORDER

1. Start the stabilizer of cross stability on the place on a stretcher.
2. Insert a stabilizer rack into a fixing opening in the suspension bracket lever. Make sure that plugs and washers are correctly installed on a carving - plugs have to be installed from each party of the lever of a suspension bracket, and a washer outside of plugs by the concave party turned to the lever.
3. Establish into place fixing nuts and tighten them with the required effort.
4. For insertion of bolts of the spherical hinge in the adjusting openings, lift the suspension bracket lever. Establish new fixing nuts and tighten them with the required effort.
5. Repeat the procedure with the second lever of a suspension bracket.
6. Install the stabilizer of cross stability in U-shaped brackets on a stretcher and tighten fixing bolts.
7. Establish to the place of a wheel, then lower the car on the earth and tighten bolts of fastening of wheels with the required effort. Establish into place decorative caps of disks of wheels.