15:22. Removal and installation to the place of tips of steering drafts

Removal

 PERFORMANCE ORDER

1. Park the car on the flat platform, cock the emergency brake and prop up back wheels. Take off decorative caps of disks of wheels and weaken bolts of fastening of wheels.
2. To Poddomkratta a car front, establish it on axial support and remove forward wheels (address Poddomkrachivaniye's Section, towage and change of wheels)
3. On each steering draft carefully measure distance between the lock-nut and a flute pierced in internal section of draft, write down result.
4. Weaken lock-nuts.  

5. Weaken a nut of fastening of a tip of steering thirst for a rotary fist of the steering mechanism, turn off a nut until the end of a carving on a hairpin - it will provide protection of a carving, and also will prevent ejection of a tip of steering draft with high speed at division of the hinge. For division of the hinge use the special tool for division of spherical hinges. Remove a nut.


6. Screw together tips of steering drafts.
7. Having taken an opportunity examine, according to the recommendations provided in the Section Replacement of Rubber Cuffs of a Steering Rack protective cuffs of a steering rack. At detection of wear or damages, replace cuffs.

Installation into place

 PERFORMANCE ORDER

1. Slightly grease carvings of steering drafts and screw new tips so that the distance between their ends and flutes pierced in drafts was in accuracy equally measured and written down in the course of removal.
2. Install the external hinge in a rotary fist, then screw and tighten a fixing nut, observing the required effort.
3. Establish to the place of a wheel and bolts of fastening of wheels, then lower the car on the earth. Tighten bolts of fastening of wheels with the required effort.
4. According to the recommendations provided in the Section Adjustment of Angles of Installation of Wheels - the general information, make check of convergence of wheels. In conclusion strong tighten lock-nuts.