15:20. Removal and installation to the place of the pump of system of hydrostrengthening of a wheel

Removal

When holding a procedure of removal / installation of the pump, avoid to apply force as it can lead to damage of bearings of a shaft to a pump shaft.


 PERFORMANCE ORDER

1. Merge hydraulic liquid from system of hydrostrengthening of a wheel (address the Section Depletion, filling and pumping of system of hydrostrengthening of a wheel).
2. Disconnect a negative wire of the battery and place it away from the plug.
3. On cars till 1994 of the issue where the tube of a mouth of the gulf of motive oil is established on a wall of a motive compartment, for ensuring access to the pump, take fixing bolts and take out a tube.
4. Remove the top basic lever of the engine.
5. Carefully clear area around an inlet hose on a pump housing - it is the hose of bigger diameter connecting the pump to the tank of hydraulic liquid. Zakuporte the open ends of a hose and port on a pump housing.
6. Give the fixing screw and remove the tank of hydraulic liquid, having shifted it in a forward part of a motive compartment for ensuring access to the pump.
7. Weaken an auxiliary driving belt (The head Routine maintenance). Take off a belt from a pulley of the pump of system of hydrostrengthening of a wheel.
8. In order to avoid pollution of hydraulic system, carefully clear area around a point of connection of the giving hose on a pump housing. Disconnect the giving hose, then a zakuporta its open end, and also port on a pump housing. There where is available, release from a clip a rope of the mechanism of decrease in transfer of transmission (kickdown) (only for automatic transmissions).
9. Remove bolts of fastening of the pump to the engine block; access to the third bolt is possible through an opening in a driving pulley.
10. Take out the pump from a motive compartment.

Installation into place

Installation of the pump of system of hydrostrengthening of a wheel is into place made as it should be, the return to a removal order.

In conclusion, make adjustment of a tension of an auxiliary driving belt (The head Routine maintenance).

Connect a negative wire of the battery, then fill and pump over hydraulic system of the power steering (The section Depletion, filling and pumping of system of hydrostrengthening of a wheel of this Chapter).