15:18. Depletion, filling and pumping of system of hydrostrengthening of a wheel

Pumping of system of hydrostrengthening of a wheel has to be made anyway after removal any of its components.

Depletion

 PERFORMANCE ORDER

1. On a wall of the liquid tank carefully clear area around a point of accession of a returnable liquid hose (it is the above-located hose of smaller diameter). Weaken a collar, then disconnect a hose. Stop up the open ends of a hose and ports of the tank.
2. Insert the free end of a returnable hose into a pure dry container capacity, at least, 1 liter.
3. Fix a container in a motive compartment, away from moving components and direct sources of heat.
4. Start the engine and allow hydraulic liquid to be extorted in a container. For pasture of liquid from a steering rack turn a steering wheel from an emphasis against the stop twice.
5. After the termination of an effluence of a stream of liquid immediately switch off ignition; do not allow rotation of the pump of system of hydrostrengthening of a wheel in dry.

Filling

Uncover a jellied mouth of the liquid tank and add in the tank hydraulic liquid of the required type and grade to the mark "maximum" (see the Head Routine maintenance).

Pumping

 PERFORMANCE ORDER

1. Park the car on a plain surface, cock the emergency brake and prop up back wheels. A car front also establish to Poddomkratta it on axial support (address Poddomkrachivaniye's Section, towage and change of wheels).
2. For pasture of the air which got to system, at the switched-off engine, slowly turn several times a steering wheel from an emphasis against the stop. Then add in the tank of fresh liquid to the mark "maximum". Repeat the procedure until liquid level in the tank does not stop falling.
3. Start the engine, then, for pasture of the air which remained in system, again slowly turn a steering wheel from an emphasis against the stop several times. Repeat this procedure several times until in the liquid tank bubbles do not stop appearing.
4. During the work the helmsman of system points existence of the abnormal noise proceeding from the pump or liquid tubes that in system there was still an air. Check this assumption, having established a steering wheel in situation "directly forward" and having switched off the engine. If at the same time liquid level in the tank rose, then at system there is an air and it is necessary to make further pumping. Again repeat the above described procedure.
5. After removal from system of hydrostrengthening of a wheel of all remains of air stop the engine and let's system cool down. In conclusion, double-check whether liquid level in the tank reaches the mark "MAX", if necessary produce dolivany liquids.