15:14. Removal and installation to the place of a tube of a back axis

Removal

 PERFORMANCE ORDER

1. Park the car on the flat platform and establish a transmission control lever in the provision of the first transfer (the manual transmission) or the selector lever in situation "P" (automatic transmission). Prop up forward wheels, you do not cock the emergency brake. Take off caps and weaken bolts of fastening of wheels.
2. A back part of the car also establish to Poddomkratta it on axial support, remove wheels (address Poddomkrachivaniye's Section, towage and change of wheels).
3. Otboltite of a bracket of ropes of the emergency brake from the lower levers of a suspension bracket.
4. Remove brake supports (see the Head the Brake system, at the same time is not present need to disconnect a support from a brake hose; tie up supports to screw springs of a suspension bracket by means of a wire or a rope, avoiding a hose tension.
5. Otboltite from an axis pipe a cross bar, tie up the free end to the body bottom that it did not prevent work.
6. Bring a jack under the central point of a pipe of an axis. For protection of a pipe insert between it and a head of a jack wooden whetstone. Cock a jack, having removed axis weight from a suspension bracket, but no more.
7. Remove a bolt which fixes the shock-absorber and the stabilizer of cross stability to a bracket on an axis pipe (address the Section Removal and installation to the place of the back shock-absorber).
8. Slowly lower a jack and remove an axis pipe from the car. As the lower levers of a suspension bracket will deviate, screw springs will unload, move away them (address the Section Removal and installation to the place of back screw springs).
9. Otboltite the leading ends of jet bars from the top part of arms of naves; tie up them in a wheel arch so that they did not prevent work.
10. Remove bolts which fix the conducted ends of the lower levers of a suspension bracket to the basis of arms of naves. For support of the lever in the course of a detachment, install the wooden block under its end.

Installation into place

 PERFORMANCE ORDER

1. Balance an axis pipe on a head of a jack and bring her under the car.
2. Lift an axis in its adjusting situation and freely establish into place bolts of fastening of an arm of a nave to the lower lever of a suspension bracket and bolts of fastening of jet bars.
3. Install screw springs perpendicularly on the lower lever (address the Section Removal and installation to the place of back screw springs).
4. Slowly lift an axis, watching that screw springs, perpendicularly rose in the top plates; during lifting of an axis support the stabilizer of cross stability so that it got on the correct parties of the support.
5. Level in adjusting brackets on axes of a pipe of the plug of shock-absorbers and stabilizers of cross stability and pass through them fixing bolts. Establish to the place of a nut and tighten them with the required effort.
6. Strong tighten bolts of fastening of a jet bar and an arm of a nave to the lower lever of a suspension bracket. Now the jack can be removed from under an axis pipe.
7. Lower into place a cross bar and pass an adjusting bolt through an axis pipe (address the Section Removal and installation to the place of a cross bar of a back suspension bracket).
8. Establish into place brake supports (see the Head the Brake system).
9. Insert into place into the lower levers of a suspension bracket clips of ropes of the emergency brake.
10. Establish to the place of a wheel and bolts of fastening of wheels, then lower the car on the earth and tighten bolts with the required effort. Establish into place caps of disks of wheels.