15:12. Removal and installation to the place of the lower lever of a back suspension bracket

Removal

 PERFORMANCE ORDER

1. Park the car on the flat platform, prop up forward wheels and establish a transmission control lever in the provision of the first transfer (the manual transmission) or the selector lever in situation "P" (automatic transmission). On the corresponding wheel take off a decorative cap of a disk of a wheel. Weaken bolts of fastening of a wheel.
2. To Poddomkratta a back part of the car, establish it on axial support and remove a wheel (address Poddomkrachivaniye's Section, towage and change of wheels).
3. Disconnect a rope of the emergency brake from the lower lever of a suspension bracket, having removed a collar with a tightening hairpin.
4. Establish a jack under the conducted end of the lower lever of a suspension bracket, then remove a bolt of fastening of the lever to an axis pipe.
5. By means of a jack lower the suspension bracket lever so that there was possible a removal of a screw spring from the place (address the Section the Brake system.
6. Disconnect the leading end of an adjusting bracket and the plug from the car floor panel by removal of two fixing bolts.

7. Take the suspension bracket lever from under the car. Check it regarding detection of signs of damage, corrosion or deformation. Examine the plug of the leading end regarding detection of signs of wear or damages; in case of a wipe, deformation or hardening of the plug as a result of aging - replace it. Similarly check the plug of the conducted end. Procedures for replacement of plugs are described in the following paragraphs.

Replacement of the plug of the leading end

 PERFORMANCE ORDER

1. Weaken a nut and take the central bolt. Take out assembly of the plug and a bracket.
2. Establish new assembly of the plug and insert the central bolt.


Do not tighten the central bolt until the lever of a suspension bracket is not installed on the car.

Replacement of the plug of the conducted end

 PERFORMANCE ORDER

1. Having firmly clamped the suspension bracket lever in a vice which sponges are supplied with soft laying for protection of an anticorrosive covering of the lever. The plug can be taken by its pushing out by means of a replaceable face head (with outer diameter a little less, than diameter of the plug). You watch that the replaceable head rested against the plug perpendicularly and you knock on a head an easy kiyanka.
2. Grease the new plug with omyvatelny liquid, then carefully insert it into the suspension bracket lever, using the same method, as at its removal.

Installation into place

 PERFORMANCE ORDER

1. Lift the suspension bracket lever to a stretcher, establish bolts of fastening of the plug of the leading end and a bracket to the car floor panel.
2. Establish on the places, on the lower lever of a suspension bracket a screw spring and a rubber saddle (address the Section Removal and installation to the place of back screw springs).
3. By means of a jack lift the suspension bracket lever for insertion of the top end of a spring in the top saddle on the floor panel.
4. Establish a bolt of fastening of the conducted end of the lever of a suspension bracket to a pipe of an axis and strong tighten it.
5. Establish into place a collar of fastening of a rope of the emergency brake on the edge of the suspension bracket lever.
6. Establish into place a wheel and bolts of fastening of a wheel then lower the car on the earth and tighten bolts with the required effort. Establish into place a decorative cap of a disk.