14:15. Removal and installation to the place of the lever of the emergency brake

Removal

 PERFORMANCE ORDER

1. Park the car on the flat platform, switch off ignition. Establish a transmission control lever in the provision of the first transfer (the manual transmission) or the selector lever in situation "P" (automatic transmission). You do not cock the emergency brake.
2. Take from the central console a cover with a bristle and remove it via the lever of the emergency brake. Release a mandrel from a clip and remove through a control lever the selector transmission / lever the protection cover. Give 4 fixing screws and remove back section of the central console (address the Head Body works).
3. Remove a plastic clamp from adjusting nuts of ropes of the emergency brake. Weaken and remove adjusting nuts, then release both ropes from brackets on a wall of the lever of the emergency brake.
4. Remove a ring clip from the end of an axial finger of the lever of the emergency brake and take a finger.
5. Remove the lever of the emergency brake from an adjusting bracket.

Installation into place

 PERFORMANCE ORDER

1. Install the lever on an adjusting bracket, then implant an axial finger, having connected the lever to a bracket / ratchet.
2. Pass ropes of the emergency brake throughout brackets on a wall of the lever and establish into place adjusting nuts.
3. Make adjustment of functioning of the emergency brake ( The section Check and adjustment of the emergency brake). In conclusion do not forget to establish into place a plastic clamp.
4. Install into place the central console, a cover of the lever of the emergency brake with a bristle and the protection cover of a control lever of the transmission / lever of the selector. You make installation as it should be, the return to a removal order (if necessary address the Head Body works).