14:14. Removal and installation to the place of ropes of the emergency brake

Removal

 PERFORMANCE ORDER

1. Park the car on a plain surface and switch off ignition. Choose the first transfer (the manual transmission) or situation "P" (automatic transmission). You do not cock the emergency brake.
2. Remove the left front seat (The head Body works).
3. Take from the central console a cover with a bristle and remove it via the lever of the emergency brake. Unscrew a mandrel and remove the protection cover from a control lever of the transmission / lever of the selector. Give 4 fixing screws and remove back section of the central console (address the Head Body works).
4. Take fixing screws and remove panels the protecting thresholds from wiping. For ensuring access to the channel of a rope, unbend a rug and unscrew a cover.
5. Remove a clamp from adjusting nuts of a rope of the emergency brake and put it aside (address the Section Check and adjustment of the emergency brake).
6. Completely weaken both adjusting screws, having disconnected them from a bracket on the lever of the emergency brake and ropes of the emergency brake.
7. Prop up forward wheels, a back part of the car and establish to a poddomkratta it on axial support (address Poddomkrachivaniye's Section, towage and change of wheels).
8. For ensuring access to brake supports remove both back wheels.
9. On the first support disconnect a rope of the emergency brake from the lever and remove a rubber casing (address the Section Replacement of Brake Shoes of Back Brakes).
10. Unscrew / выковырните from the lower lever of a suspension bracket a rope guide.
11. Release the remained rope, having extended it via the sealing plug in the floor panel - now assembly of a rope can be taken from the car.
12. Repeat the procedure described above for the second rope.

On cars after 1988 the issue for extraction of ropes of the emergency brake will be required to lower slightly the fuel tank from the seat (address the Head Toplivnaya and exhaust systems).

Installation into place

 PERFORMANCE ORDER

1. Pass the end of the first new rope through the sealing plug throughout floor panels.
2. Screw in / insert other end of a rope into a spring guide on the lower lever of a suspension bracket.
3. From within the car stretch a rope to a bracket in the basis of the lever of the emergency brake. Screw the adjusting screw on the end of a rope, however do not tighten it completely.
4. On a support fill the rubber protection cover lubricant and pass through it a rope of the emergency brake. Hook on a rope cover for a cut in the bracket established on a support and connect a rope to the lever of the emergency brake.
5. Repeat the procedure described above for installation of the second rope.
6. On cars after 1988 lift the issue and install into place the fuel tank, having fixed its support (address the Head Toplivnaya and exhaust systems).
7. For a tension and shrinkage of ropes several times cock the emergency brake.
8. Make adjustment of a tension of ropes of the emergency brake (address the Section Check and adjustment of the emergency brake).
9. Establish to the place of a wheel, then lower the car on the earth and tighten bolts of fastening of wheels with the required effort.
10. In the car screw in covers of ropes and put back a rug. Establish to the place of the panel, the protecting thresholds from deleting.
11. Install into place the central console, the lever of the emergency brake, a cover by a bristle and seats.
12. Before starting operation of the car, make full check of functioning of the emergency brake.