12.3. Adjustment of a rope of the selector

Scheme of connection of the lever of the selector with a selector rope



And — the selector Lever
In — a selector Rope
With — the Adjusting nut


D — selector lever casing Bolts
E — the transmission selector Lever


 PERFORMANCE ORDER

1. Park the car on a plain surface, then without cocking the emergency brake, install the selector lever in situation "N". At the started engine make sure that driving wheels are completely disconnected from the engine (increase engine turns to speed about 2000 rpm and make sure that the car at the same time does not start). Cock the emergency brake and switch off ignition.
2. In the car remove fixing screws and remove the cover panel from the selector lever basis.
3. In a point of accession of a rope of the selector to the lever of the selector weaken an adjusting nut, having provided the free movement of a rope.
4. Move the selector lever in situation "N".
5. Tighten an adjusting nut with the required effort.
6. Install into place the panel of a cover and fixing screws.
7. As follows check adjustment of a tension of a rope of the selector. Transfer the selector lever at first to situation "P", then to situation "1" and make sure that in these provisions there is no rope side play. Transfer the selector lever to situation "D" (movement) and make sure that at transfer of the lever to situation "3" the rope side play is also absent. Transfer the selector lever to situation "R" and make sure that at transfer of the lever to situation "P" the side play of a rope is absent. In conclusion make sure that at position of the lever of the N selector transmission really is established in neutral situation.
8. Make road check of transmission, having made sure that smooth switching of transmission in provisions of all transfers is provided.